Installation: Before installing, make sure to clean the area where the gasket is being
installed. For snap-in style gaskets the track must be clean of any debris or glue from the previous gasket. If the gasket
has been folded or is distorted from shipping, You can use an electric hair dryer, heat lamp or immerse in
hot water 140-160 degrees to get the gasket back in shape. Be careful when handling so you do not to break the magnet.
If you happen to tear the vinyl you can repair it with a soldering iron or vinyl cement. When installing it is best to install
the corners and then start in the middle and work your way up or down to the corner. If the gasket becomes Twisted or out
of shape while installing try and use a blow dryer to soften the rubber then close the door and let seal. Try not
to stretch the gasket!